Cold bending machine punch cutting capac

　　In the cold forming production line, it is often necessary to punch cutting device to complete the automatic production of the whole equipment. These cutting devices can be installed in front of the molding machine according to the production needs of the workpiece, in the molding archway (that is, in the middle of the main machine), after the cold bending molding machine, or there are some processes that can not be completed in a line, can be punched separately after molding. In the application of punching, punching machine is the most commonly used equipment, and hydraulic punching, flying saw, laser, plasma, laser and plasma cutting cost is expensive, generally in some special needs, or conventional punching way can not be completed in the case of this way to punching.

　　Cold bending molding machine can be applied on the punch punch, slotting, bending, or marking, in the comparison of bed, other commonly used ways and the movable, hydraulic punch. The operation of these presses is usually controlled by a number of pulses transmitted by feeders, length encoders, and optical fibers.

　　Cold bending molding machine used on the punch cutting capacity is usually expressed in tonnage, that is, the punch through the die exerted on the workpiece instantaneous or continuous maximum punch force. The punching capacity of a mechanical punch is usually calculated by the punching capacity of 3mm above the lower dead point. The punching capacity of the pneumatic punch is usually determined by the sum of the forces imposed by the cylinder, the pipe and the moving slider. The cutting capacity of the hydraulic press is determined by the force produced by the hydraulic cylinder.